$1,250.00
STOCK HARNESS OUT OF VEHICLE IS REQUIRED TO BE SENT IN. THIS IS THE HARNESS THAT YOU ARE INSTALLING YOUR NEW ENGINE INTO.
OUR DIRECT-FIT HARNESSES ARE BUILT COMPLETELY CUSTOM TO YOUR ENGINE SPECIFICATIONS. THESE HARNESSES WILL RETAIN ALL FACTORY GAUGES, AIR CONDITIONING, ABS BRAKES AND CRUISE CONTROL WHERE APPLICABLE.
WHEN WE SAY CUSTOM BUILT WE MEAN IT. THE HARNESS WILL BE BUILT TO MATCH YOUR EXACT INJECTOR STYLE, MAP SENSOR, MASS AIR FLOW SENSOR ETC.
THE DIFFERENCE BETWEEN A DIRECT-FIT HARNESS AND A STAND-ALONE HARNESS IS THAT A DIRECT-FIT IS COMPLETELY PLUG AND PLAY JUST REINSTALL IN YOUR TRUCK AND TURN THE KEY, A STAND-ALONE WILL SIMPLY ALLOW THE ENGINE TO RUN BUT PROVIDES NO INTEGRATION INTO THE TRUCK ITSELF.
GEN 4 ENGINES WILL REQUIRE A FUEL-LINK FOR PROPER FUEL GAUGE CALIBRATION (98+ ONLY) AND IF CRUISE CONTROL IS TO BE RETAINED WILL REQUIRE DAKOTA DIGITAL CRUISE CONTROL MODULE.
ALL HARNESSES COME WRAPPED IN A BRAIDED SLEEVING FOR THAT ONE OF A KIND SHOW FINISH.
ECM PLACEMENT IS ON DRIVERS FENDER IN FACTORY LOCATION EXCEPT ON 1995 WHICH IS BEHIND GLOVEBOX IN FACTORY LOCATION.
NOTE: HARNESSES REQUIRE THE FOLLOWING SENSORS:
NOTE: THESE HARNESSES HAVE A LEAD TIME, PLEASE CHECK THE LEAD TIME PAGE LINK AT TOP FOR CURRENT LEAD TIMES.
NOTE: WHEN MAILING IN ORIGINAL HARNESS PLEASE REMOVE FACTORY BATTERY CABLE, FUSES/RELAYS AND FUSE BOX MOUNTING BRACKET. DO NOT SEND IN ANY FACTORY COMPUTERS, FRONT LIGHT HARNESS OR 4WD HARNESS.
NOTE: THESE HARNESSES ARE NON-REFUNDABLE
